Thegreywizard
- 99
- 18
Ok I don't know where to go from here, I thought I had everything dialed in.
Even though the clones had no roots after 10 days, they still looked pretty good on top.
But then a few days ago I noticed I have mold every where all over the foam pucks
This is a Turbo Kloner
I am running a full AC Infinity setup and have it sealed, but exhausted with a humidifier to keep my VPD at 0.7 - and it's been working perfectly holding that VPD
But that keeps my humidity around 70% and I'm assuming that's where all of this mold came from as I didn't have this on my first run with this setup.
I've added a 1/10th chiller to this since then and have been keeping all of my numbers super dialed in:
PH - 5.8
Humidity - 70% +/-
Temp - 74*
VPD - 0.7
Water temp - 69*
PPMs - 700
AC Infinity LED - 40% brightness
I'm using Jacks Clone formula and using RO water
I have a Bluelab Guardian, AC Infinity 69 Pro Controller & brand new chiller. So I know all of these numbers are correct and have been stable this whole time too. I don't even have to open the tent for days, it's incredible how automated it all is. I still check it daily through the window. But I figured just leave it sealed to the humidity stays high and the clones can root faster.
But why are my clones still not showing any roots after 10 days?
The foliage has definitely grown, but just no roots yet still. I know it can take 14-21 days in aero-cloners, but I've also seen people get roots in 10 days too.
And why is all of this mold forming? (it's not on the plants, just the foam pucks)
Even though the clones had no roots after 10 days, they still looked pretty good on top.
But then a few days ago I noticed I have mold every where all over the foam pucks
This is a Turbo Kloner
I am running a full AC Infinity setup and have it sealed, but exhausted with a humidifier to keep my VPD at 0.7 - and it's been working perfectly holding that VPD
But that keeps my humidity around 70% and I'm assuming that's where all of this mold came from as I didn't have this on my first run with this setup.
I've added a 1/10th chiller to this since then and have been keeping all of my numbers super dialed in:
PH - 5.8
Humidity - 70% +/-
Temp - 74*
VPD - 0.7
Water temp - 69*
PPMs - 700
AC Infinity LED - 40% brightness
I'm using Jacks Clone formula and using RO water
I have a Bluelab Guardian, AC Infinity 69 Pro Controller & brand new chiller. So I know all of these numbers are correct and have been stable this whole time too. I don't even have to open the tent for days, it's incredible how automated it all is. I still check it daily through the window. But I figured just leave it sealed to the humidity stays high and the clones can root faster.
But why are my clones still not showing any roots after 10 days?
The foliage has definitely grown, but just no roots yet still. I know it can take 14-21 days in aero-cloners, but I've also seen people get roots in 10 days too.
And why is all of this mold forming? (it's not on the plants, just the foam pucks)
Last edited: